Running End: The part of a rope that is free. ![]() Bitter End: The part of a rope that is tied off.Grip: Slides which incorporate a loop for a grip.Slide: Knots used to tie onto another line which can be moved along the line as needed.Stoppers: Knots tied at the end of a line to prevent the line from running through devices such as cleats or pulleys.Mid Loops: Knots which form a loop in the middle of a line.End Loops: Knots which form static and non-static loops at the end of a line.Mat: A knot which uses connecting loops in a rope to create a flat surface or net.Bend: A knot used to tie two lengths of rope together.Hitch: A knot tied on purpose with the intent of being able to untie when necessary.Knot Termsįirstly it is a good idea to get acquainted with major knot terms. Speaking of proper names, it might be helpful to go through a few that pop up from time to time when talking about knots. But, if a cantankerous sea Captain angrily corrects your nomenclature don’t say I didn’t warn you. That is the important part of any decent knot tying guide, not the names. Now, I don’t care if you call them knots or hitches as long as you know how to tie them and when to use which one. See also: Types of Rope for The Outdoors: Tying It All Together It was the first of many truths I learned from him. He also told me knots were accidents which can’t be untied. When I asked, he grew sterner and informed me the proper name was reef hitch. I looked closely at his creation and was confused. Laughing, he took the line and quickly formed a perfect knot. He could see my discomfort and didn’t help matters when he told me the reef hitch was the easiest thing in the world to tie. I had even worked as a commercial fisherman in Alaska. I was a boy scout and an avid sailor for years before this test. After twenty minutes of hard questions, he pulled out a small length of line and flipped it toward me, asking me to tie a reef hitch. ![]() I was applying to work as a deckhand on a private yacht and the Captain, a former British Navy officer, really put me through the paces. Pull all strands tight and make sure you have at least 6 inches of tail on the working end.I still remember my first real job interview. Once it’s all traced through, you should have five sets of parallel lines in the knot neatly next to each other. Then, thread the working end back through the original figure-eight, tracing the original knot. Pull this tight to achieve your first figure-eight knot.įor the follow-through, if tying into a harness, thread the working end through both tie-in points on the harness and pull the figure-eight close to you. Wrap the working end around the base of the loop once, then poke the end through the loop from front to back. ![]() Make a bight at that point to create a loop with the working end on top. To make this knot, hold the end of the rope in one hand and measure out from your fist to your opposite shoulder. It ties you into your harness as a climber. This knot, also known as the trace-eight or rewoven figure-eight, is one of the first knots every rock climber will learn.
0 Comments
Leave a Reply. |